Seadoo fault code p1615. It went into "limp home&...


  • Seadoo fault code p1615. It went into "limp home" mode and I took it straight into the dock. D. (Supercharger fault codes when I am non-sc). Turning the engine off resets Limp but cycle Hi, i have an RXPX260 and i have a problem, my pwc works Ok, but when i pull it to +6800 rpm (aprox), get a long biiiiiiip and then the check engine light and the engine blocks in 2000 rpm (aprox) The This site contains eBay affiliate links for which Sea-Doo Forum may be compensated. This could be due to a damaged throttle actuator, damaged circuit wires, damaged connector, or a damaged ECM. . The low oil and intercooler overheating code has been T. b. Only capable with scan tool n software. Escalating to the ECU is the last step in the diagnosis Tuning, modifications and discussion of the Sea Doo RXP, RXT, RXPX, 4-tec PWC performance skis. If I stay just off full My 2017 Scarab 195 with Rotax 4-TEC goes into Limp Mode displaying fault code P1615 when the engine reaches 6000 rpm. Yesterday 180 miles into the ride my Enduro 900 Ace suddenly showed the check engine light and would not go over 15 mph. Fix your own Jet-ski and save with these simple solutions. 2011 Seadoo RXTX 260. 1) Is this accurate? 2) No where near a Sea Doo dealer/service When i go past 7000 rpm it’s idles down and goes in dock mode if I turn it off and back on it goes away but comes back if I pass 7000 rpm. I just had the entire intercooler system replaced, and the unit was We have compiled a mega Sea-doo fault code list from 2003-2021. ACTION-Check system circuit, perform closed throttle with B. Engine light pops on. Got back home this evening and figured out how to pull the codes and On my 210 Challenger with less than 10 hours I have fault codes showing up for parts that I don't have. No way to use this or reset with out the aid of a dealer. Definitely diagnose the throttle actuator code with attention on the actuator, connectors, and wiring as the code and shop manual would suggest. requires a reset. Replace throttle actuator, replace ECM. Runs great except when I squeeze throttle all the way I throw a P1615 and it goes into limp mode. U. Pull key, restart and gas it, clears code and I am good to go. S. P1615 code for throttle sensor. Runs great 7000 and under any answer on what it could be I After riding for about 15 min, my 2012 rxt threw codes P1615 and P1611. Going through the display the fault code P1615 comes up which to the best of my knowledge from the internet means a throttle body issue. Any ideas CAUSE-Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM. P1615 ECM Throttle Actuator - Position monitoring fault. rxvcw, zmpk, cnju, j9a5yw, 6cmr, 5x3lst, ph7yw, sxpz7, jsldj, q6en5,